Installation direction of the electric ball valve in the valve The electric ball valve can be used as a pipeline compensation joint for the connection of the valve. The electric ball valve is the key part for connecting the water pump and the electric ball valve. The electric ball valve can transmit the axial thrust in the electric ball valve, so that the pump valve and the electric ball valve can be connected as a whole. When the electric ball valve is connected with the electric ball valve, if the flange plate and gasket are not strong enough, the connecting bolt is short or the diameter is thin. The thermal electric ball valve uses valve gasket, the cold water electric ball valve uses asbestos gasket, and the double-layer gasket or bevel gasket is used. The flange gasket protrudes into the pipe. These phenomena will make the flange connection not tight, or even damaged, resulting in leakage.
The flange gasket protrudes into the pipe, which will increase the water flow resistance. The electric ball valve can be used in different directions. During installation, attention should be paid to the following: the water flows through the inner pipe of the electric ball valve first, then through the connection between the electric ball valve pipe and the electric ball valve body, and then through the electric ball valve body to the pipe. During the installation of electric ball valve, attention shall be paid to: the water flow shall first pass through the end of the inner pipe of the electric ball valve, then flow through the connection between the electric ball valve pipe and the electric ball valve body, and then flow through the electric ball valve body to the pipe.