What should we pay attention to when using the pneumatic ball valve?
As the saying goes: no rules, no radius. Everything has its own rules when it is used. If it is violated, there may be risks. Pneumatic ball valves are no exception when they are installed.
1. When installing damper ball valve vibration isolator for horizontal water pump unit, under normal circumstances, the damper shall be fixed with the air, inert block or section steel base by connecting nut.
2. When the shock absorber of the unit has six mounting points, four of them are arranged at the four corners of the inertia block or section steel frame, and the other two should be set on the long side line, and their positions should be adjusted so that the compression deformation of the shock absorber is as different as possible.
3. The side line of the pneumatic ball valve shall not exceed the side line of the inert block; The supporting area of the steel frame shall not be less than the area of the shock absorber.
4. Before construction and installation, timely inspection shall be carried out. During installation, the static tightening deformation of pneumatic ball valve shall not exceed the maximum allowable value.
5. During the installation of the pump unit, the supporting air for the installation of the pump unit shall be flat and have sufficient bearing ability.
6. When the vibration isolator of vertical water pump unit is installed under the base of the water pump unit, a section steel base shall be set and anchored; The section steel base and the pneumatic ball valve shall be fixed with bolts (with ball valve washers). The foundation bolts are set in the air or floor, and the shock absorber is fixed in the air or floor after the foundation bolts.