The pneumatic ball valve of the filling machine uses compressed air as the main power source. It is filtered into dry and clean gas by the triplet (filter, pressure regulator, oil mist) carried in the machine, and then sent to the pneumatic ball valve actuator to drive the ball valve to rotate 0-90 degrees to open or close the valve. Proper fuel injection of the atomizer can ensure that the system works in a good environment. Working principle: the barrel pushing cylinder of the filling machine acts synchronously with the pneumatic actuator of the pneumatic valve. The pneumatic valve cylinder of the filling machine lifts the elbow and pushes the barrel cylinder into a barrel. When the pneumatic valve drops, the barrel pushing cylinder retracts. At this time, the positioning cylinder acts to push the barrel tightly against the brush. The brush of the barrel brushing machine operates continuously. The brush drives the empty barrel to rotate when brushing the barrel, Therefore, every part of the empty barrel can be brushed. The washed empty barrels are pushed to the rinsing station by the barrel pushing cylinder to clean the empty barrels, then the empty barrels behind are pushed into the upper barrel rack, and then the upper barrel rack is turned up by the upper barrel cylinder, and the empty barrels slide freely into the barrel seat.

Relevant information Analysis of what to pay attention to when installing electric control valve Analysis of what faults the oil distribution brings to the pneumatic control valve Analysis of what problems the pneumatic butterfly valve will have in application and use Analysis of the causes and solutions of internal leakage of electric control valve Analysis of the principles to be followed when installing pneumatic control valve