Vibration management of lateral seismic support
Method I of reducing lateral seismic support vibration
Increase the lateral seismic support of products to save the power of equipment. In the application of different moving orientation planning, the resistance of the floor can be improved. In terms of the acceptance of moving external accessories, it can reduce the incidence of exhaust rollover and increase the foundation of robust rollover control characteristics in the exhaust pipe.
Method II of reducing lateral seismic support vibration
The strength of the vent support frame is billowing. Among the application accessories of various steel structures, it increases the role of the operation control degree of different flow wind forces with high strength, improves the strong support frame of different jet billowing process products, and improves the process of reducing stress wear of different steel strengths.
Method III of reducing lateral seismic support vibration
The reduction of pressure friction in the application of vibration force can prevent the water level of the force from swelling, regulate the high application force in different steel support frames and reduce the phenomenon that the power of swing or vibration is difficult to operate.

The premise of using electromagnetic flowmeter is that the measured liquid must be conductive and not lower than the threshold value (i.e. the lower limit value). If the conductivity is lower than the threshold value, the measurement error will occur until it cannot be used. If the conductivity exceeds the threshold value, it can be measured even if it changes. The indication error changes little. The threshold value of the universal electromagnetic flowmeter is between 10-4 and (5 × 10-6) S/cm, depending on the model. The use also depends on the length of the flow signal line between the sensor and the converter and its distributed capacitance. The manufacturer's operating instructions usually specify the length of the signal line corresponding to the conductivity.