Organizational structure of pipe seismic support and hanger
The seismic support mainly transmits the seismic action to the building structure through the connection with the base, so the bearing capacity is strong. Therefore, when designing drawings, the layout of buildings and circuits should be reasonable, and reasonable design must be stopped. The device is direct, and the workers should strictly follow the requirements of the design drawings to ensure the correct position of the seismic support, so as to ensure the quality of the electrical wiring device project.
On the premise of purchasing advanced shockproof support accessories and advanced electrical wiring device equipment, it is very necessary to stop technical training for device personnel. Since the good quality of the project will directly affect the safe use and seismic performance of power in the future, and since the seismic support can effectively ensure the seismic effect of buildings, the correct installation technology of the installation personnel will be conducive to seismic engineering.
We all know the importance of seismic support to the normal operation of electrical equipment. Therefore, on the premise of reasonably designing the location of seismic support and hanger, we also need to make a request for the layout and device of power lines, to ensure that the installation of seismic support for each node combination is completely transformed, the device of power lines is reasonably improved, and the line is embedded well.

Precautions for application of stainless steel pneumatic butterfly valve:
1. When using stainless steel pneumatic butterfly valve, be careful to open the package, do not disturb the pipe to avoid causing tangle, then cut the required length, and put the harness or wire into it. If the wire is thinner or more, try to choose a harder hose connector, so it is easier to put the harness into it. If water or other liquids are required, Install the cut pipe with water to check whether it will leak, so as to avoid disassembly after installation.
2. If it is used on large machinery or automobile wire harness, it is recommended that the hose be cut apart for use. Because ordinary large machinery wire harness is longer and more, it may not be convenient to pass through. If it is cut open and put directly, it will save labor. When the wire is put in, it is better to fix it with adhesive tape.